Shenzhen Merrytek Technology Co., Ltd.
Shenzhen Merrytek Technology Co., Ltd Intelligent Lighting Control
Add to Cart
On-demand lighting control KNX motion detectors pir movement sensor switch for smart building control
1. Features
1) PIR motion detection
2) KNX bus power and KNX communication available
3) Daylight sensor detection is available
4) Detection area, and hold time can be set by remote or ETS
5) Max detection range: 2.5-8m in diameter
6) Warehouse, workshop, and lobby motion detection is highly recommended
7) Flush mounting or surface mounting optional
2. Parameters
| Input/Output | Input voltage | 21-30V DC KNX bus power |
| KNX current | ≤10mA | |
| Consumption | ≤0.5W @24V DC | |
| Sensor parameter | Function | PIR motion detection+ daylight sensor |
| Detection Area | ETS setting:8%/16%/24%/32%/40%/48%/56%/64%/72%/80%/88%/100% | |
| Hold Time | ETS setting | |
| Radius detection range(based on 100% sensitivity) | 2.5-4m @25℃ based on 3m mounting height | |
| Remote control | Available | |
| Mounting height | 2-6m typical value:3m | |
| Application environment | Drill hole | Φ60mm |
| Working temperature | -25℃...+50℃(detection range might differ based on different temperature ) | |
| Storage temperature | -40℃~+80℃ | |
| Warranty | 3 years(available based on product quality problem) | |
| Certificate Standard | Certificate | Compliant to CE |
| Environmental requirements | Compliant to RoHS | |
| IP rating | IP20 | |
| “N/A” means not available | ||
3. Dimension
4. Wiring Diagram
Wiring recommendations:
1. KNX bus wiring suggestion hand in hand to the end, star, or tree wiring is not recommended to ensure the stability of signal transmission.
2. KNX bus wiring wire recommends KNX standard EIB shielded wire or Category 6 network cable, the length of the bus wiring is recommended not to exceed 400 meters, and the number of sensor connected to a bus is recommended to not exceed 12.
3. The number of sensors connected to a bus needs to fully consider the current load capacity of the power supply: that is the sum of the currents of all KNX devices (including sensors) shall not be greater than the load current of the KNX power supply.
5. Start Process & Initialization
After routing the physical addresses and setting the channel parameters, follow these steps:
(1) Connect Bus interface;
(2) Set Bus and auxiliary power on (note: please make sure that product has auxiliary power supply, otherwise the device may not work properly);
(3) Press the programming switch of the product, the LED light will turn red;
(4) Use the bus interface to download the physical address through the ETS software. The programming LED light is off to indicate that the physical address download is successfully completed;
(5) Download the application after setting the required application parameters.
(6) After downloading the application, the product goes into initialization. During initialization, the detection function is disabled. After 20S, the initialization is completed, and the product works normally;
Note: Please use the latest version of ETS 5 or 5.7.2 version. Please obtain thee ETS engineering configuration file of this sensor from our sales staff.
6. Detection radiation
7. Detection Signal
The product detects human moving signals and below is a description of the moving signals:
Moving signal: detect the human significant moving (walking) in the detection area.
8. Remote Control (MH10)